Konigstiger (Porsche Turret)

Download Papercraft 

Tiger II is the common name of a German heavy tank of the Second World War. The final official German designation was Panzerkampfwagen Tiger Ausf. B, often shortened to Tiger B The ordnance inventory designation was Sd.Kfz. 182. It is also known under the informal name Königstiger (the German name for the Bengal tiger), often translated literally as Royal Tiger, or somewhat incorrectly as King Tiger by Allied soldiers, especially by American forces.

The Tiger II was the successor to the Tiger I, combining the latter's thick armour with the armour sloping used on the Panther medium tank. The tank weighed almost 70 tonnes, and was protected by 100 to 185 mm (3.9 to 7.3 in) of armour to the front. It was armed with the long barrelled 8.8 cm KwK 43 L/71 anti-tank cannon. The chassis was also the basis for the Jagdtiger turretless tank destroyer.

The Tiger II was issued to heavy tank battalions of the Army and the Waffen-SS. It was first used in combat with 503rd Heavy Panzer Battalion during the Allied Invasion of Normandy on 11 July 1944; on the Eastern Front, the first unit to be outfitted with Tiger IIs was the 501st Heavy Panzer Battalion, which by 1 September 1944 listed 25 Tiger IIs operational.

Development

Development of a heavy tank design had been initiated in 1937; the initial design contract was awarded to Henschel. Another design contract followed in 1939, and was given to Porsche.Both prototype series used the same turret design from Krupp; the main differences were in the hull, transmission, suspension and automotive features.

The Henschel version used a conventional hull design with sloped armour resembling the layout of the Panther tank. It had a rear mounted engine and used nine steel-tired, eighty centimeter diameter overlapping road wheels per side with internal springing, mounted on transverse torsion bars, in a similar manner to the original Henschel-designed Tiger I. To simplify maintenance, however, as when the same steel-tired road wheels were used on later Tiger I hulls, the wheels were only overlapping without being interleaved — the full Schachtellaufwerk rubber-rimmed roadwheel system that had been in use on nearly all German half-tracks used the interleaved design, later inherited by the early production versions of the Tiger I and Panther.

The Porsche hull designs included a rear-mounted turret and a mid-mounted engine. The suspension was the same as on the Elefant tank destroyer. This had six road wheels per side mounted in paired bogies sprung with short longitudinal torsion bars that were integral to the wheel pair; this saved internal space and facilitated repairs. One Porsche version had a gasoline-electric drive (fundamentally identical to a Diesel-electric transmission, only using a gasoline-fueled engine as the prime mover), similar to a gasoline-electric hybrid but without a storage battery; two separate drive trains in parallel, one per side of the tank, each consisting of a hybrid drive train; gasoline engine – electric generator – electric motor – drive sprocket. This method of propulsion had been attempted before on the Tiger (P) (later Elefant prototypes) and in some US designs, but had never been put into production. The Porsche suspension were later used on a few of the later Jagdtiger tank destroyers. Another proposal was to use hydraulic drives. Dr. Porsche's unorthodox designs gathered little favour.

Design

Henschel won the design contract, and all Tiger IIs were produced by the firm.Two turret designs were used in production vehicles. The initial design is often misleadingly called the "Porsche" turret due to the belief that it was designed by Porsche for their prototype; in fact it was the initial Krupp design for both prototypes. This turret had a rounded front and steeply sloped sides, with a difficult-to-manufacture curved bulge on the turret's left side to accommodate the commander's cupola. Fifty early turrets were mounted to Henschel's hull and used in action. The more common "production" turret, sometimes called the "Henschel" turret, was simplified with a significantly thicker flat face, no shot trap (created by the curved face of the earlier turret), and less-steeply sloped sides, which prevented the need for a bulge for the commander's cupola, and added additional room for ammunition storage.

The turrets were designed to mount the 8.8 cm KwK 43 L/71 gun. Combined with the Turmzielfernrohr 9d (German "turret telescopic sight") monocular sight by Leitz, which all but a few early Tiger IIs used, it was a very accurate and deadly weapon. During practice, the estimated probability of a first round hit on a 2 m (6 ft 7 in) high, 2.5 m (8 ft 2 in) wide target only dropped below 100 percent at ranges beyond 1,000 m (0.62 mi), to 95–97 percent at 1,500 metres (0.93 mi) and 85–87 percent at 2,000 m (1.2 mi), depending on ammunition type. Recorded combat performance was lower, but still over 80 percent at 1,000 m, in the 60s at 1,500 m and the 40s at 2,000 m. Penetration of armoured plate inclined at 30 degrees was 202 and 132 mm (8.0 and 5.2 in) at 100 m (110 yd) and 2,000 m (1.2 mi) respectively for the Panzergranate 39/43 projectile (PzGr—armour-piercing shell), and 238 and 153 mm (9.4 and 6.0 in) for the PzGr. 40/43 projectile between the same ranges. The Sprenggranate 43 (SpGr) high-explosive round was available for soft targets, or the Hohlgranate or Hohlgeschoss 39 (HlGr—HEAT or High-explosive anti-tank warhead) round, which had 90 mm (3.5 in) penetration at any range, could be used as a dual-purpose munition against soft or armoured targets.

Powered turret traverse was provided by the variable speed Boehringer-Sturm L4S hydraulic motor, which was driven from the main engine by a secondary drive shaft. A high and a low speed setting was available to the gunner via a lever on his right. The turret could be rotated 360 degrees in 60 seconds in low gear independent of engine rpm, in 19 seconds with the high speed setting and engine at 2000 rpm, and within 10 seconds at the maximum allowable engine speed of 3000 rpm. The direction and speed of traverse were controlled by the gunner through foot pedals, or a control lever near his left arm. If power was lost, such as when the tank ran out of fuel, the turret could be slowly traversed by hand, assisted by the loader who had an additional wheel. Two full turns of the wheel were necessary for a one degree turn of the turret, with a total of 720 turns for a full circle.

Like all German tanks, it had a petrol engine; in this case the same 700 PS (690 hp, 515 kW) V-12 Maybach HL 230 P30 which powered the much lighter Panther and Tiger I tanks. The Tiger II was under-powered, like many other heavy tanks of World War II, and consumed a lot of fuel, which was in short supply for the Germans. The transmission was the Maybach OLVAR EG 40 12 16 Model B, giving eight forward gears and four reverse, which drove the steering gear. This was the Henschel L 801, a double radius design which proved susceptible to failure. Transverse torsion bar suspension supported the hull on nine axles per side. Overlapped 800 mm (31 in) diameter road wheels with rubber cushions and steel tyres rode inside the tracks.

Like the Tiger I, each tank was issued with two sets of tracks: a normal "battle track" and a narrower "transport" version used during rail movement. The transport tracks reduced the overall width of the load and could be used to drive the tank short distances on firm ground. The crew were expected to change to normal battle tracks as soon as the tank was unloaded. Ground pressure was 0.76 kg/cm² (10.8 psi).

Command variant

The command variant of the Tiger II was designated Panzerbefehlswagen Tiger Ausf. B. It had two versions, Sd.Kfz. 267 and Sd.Kfz. 268. These carried only 63 rounds of 8.8 cm ammunition to provide room to accommodate the extra radios and equipment, and had additional armour on the engine compartment. The Sd.Kfz. 267 was to have used FuG 8 and FuG 5 radio sets, with the most notable external changes being a two metre long rod antenna mounted on the turret roof and a Sternantenne D ("Star antenna D"), mounted on an insulated base (the 105mm Antennenfuß Nr. 1), which was protected by a large armoured cylinder. This equipment was located on the rear decking in a position originally used for deep-wading equipment.The Sd.Kfz. 268 used FuG 7 and FuG 5 radios with a two-metre rod antenna mounted on the turret roof and a 1.4 metre rod antenna mounted on the rear deck.

Production

The Tiger II was developed late in the war and built in relatively small numbers. Orders were placed for 1,500 Tiger IIs — slightly more than the 1,347 Tiger I tanks produced — but Tiger II production was severely disrupted by Allied bombing. Among others, five raids between 22 September and 7 October 1944 destroyed 95 percent of the floor area of the Henschel plant. It is estimated that this caused the loss in production of some 657 Tiger IIs.Only 492 units were produced: one in 1943, 379 in 1944, and 112 in 1945. Full production ran from mid-1944 to the end of the war.

The Tiger II served as the basis for one production variant, the Jagdtiger casemated tank destroyer, and a proposed Grille 17/21/30/42 self-propelled mount for heavy guns that never reached production.